I have the following issue when trying to bridge coppermine and SMF 2.0.5:
"You don't have permission to access this page."
Coppermine install:
http://inkscapecommunity.com/ic_galleryBridging app install:
http://forum.inkscapecommunity.comCoppermine version: cpg1.5.24
Bridging app version: SMF 2.0.5, with Tiny Portal 1.107
Test user account: don't have one yet, not sure how to set up, see below please
BridgeManager settings:
Bridge app URL:
http://mysite.tld/test/foo_bar (I don't understand how this should be different from
http://forum.inkscapecommunity.com. However, Bridge Manager did not ask for this.)
Relative path to your bridge app's config file: ../forum/
Cookie name or prefix: forum (The Bridge Manager does not ask me for cookie info.)
Use bridge app custom groups?: 1
Here's what happens. After I click Finish, to enable the bridging, I get the same page, except the Finish and Back buttons are gone, and instead there's a "Start bridging wizard" button. It seems like nothing has happened. But when I go to Users > Group, I get the "You don't have permission to access this page." error. When I click Login, I get my forum's login page. But after I'm logged in, there's no gallery there, or any new Gallery tab. It's just my forum (portal).
I've tried the steps for "Recover from failed bridging" in the manual. But when I enter
http://inkscapecommunity.com/ic_gallery/bridgemgr.php, it does not take me to a login page, as the manual indicates. It just shows me the 1st Bridge Manager page that I started with. So it seems that I am unable to switch off the integration.
I don't know how to create a test user for you, assuming that means an unbridged gallery user, since I can't undo the failed bridge. If you can tell me how, I'll do that right away. However, I can give you a test forum user, if that would help.
I'm not sure what might have gone wrong. I was very confused about the relative path, which is asked for in the Bridge Manager. Since my forum is on forum.inkscapecommunity.com subdomain, there isn't an example for that, in the manual where it explains how to write the relative path. In the part of the manual where it tells you where to install the gallery, to make a successful bridge, it gives examples of the file path from the webroot. So it did look to me like I had it set up according to the file path. But I'm also quite confused about how subdomains are indicated as far as the file path. (For example, forum.inkscapecommunity.com seems to be the same as webroot/forum. But webroot/ic_gallery (same level in the file structure) is at inkscapecommunity.com/ic_gallery, which is not a subdomain.)
Anyway, in summary, I can't seem to switch off the integration, in order to start all over. And once I do that, and try again, I'm not sure if the relative path was wrong, or if there is some other problem.
Thank you very much