i clicked for it to update and it says it was updated
Not sure what you clicked (probably some silly interface in your webhost's control panel that say "update everything automatically"; which is just wishfull thinking). Anyway, auto-installers suck and go unsupported. Read up the
documentation how to upgrade, because that's the only method that will work.
i tried to figure out the URI fields thing
Reading the docs usually helps:
Upload troubleshooting
If you are experiencing issues with coppermine's upload process, temporarily change your coppermine settings as suggested below to get more detailed error messages. This applies to all upload methods, not only HTTP uploads.
* Log in as admin
Go to your coppermine page and log in as admin
* Go to the config screen
* Scroll to the bottom of the page
* Expand the "Maintenance settings" section by clicking on it
* Enable debug mode for everyone
(set Enable debug mode to "Yes: Everyone")
* Leave display of notices switched off
(notices are only meant for developers. If you have idea what they mean, leave them off.)
* Save the new settings by clicking on "Save new configuration"
* Go to the "groups" panel
* Set the upload form configuration for all groups to "Single file uploads only"
1. set File upload boxes to "1" (1)
2. set URI upload boxes to "0" (2)
3. set No. of boxes to "fixed" (3)
# Save your new settings
(click on "Apply Modifications")
Then try to upload (using http uploads, even if you experienced troubles using another upload method) - you should get a more detailed error message that tells you what exactly goes wrong with your uploads. If the error message doesn't mean anything to you, search the support board for the error message you get.
You set the number of URI upload fields on the groups control panel - that's not so hard to understand. Set that to zero.
idk
I told you to write plain English. As you ignored what I said I will subsequently ignore you: I'm out of this thread.