Topic: Removing the groups that were inputted by coppermine after bridge (Read 2869 times)

SeanK · « **on:** April 21, 2006, 06:01:23 pm »

Coppermine 1.4.4 and SMF 1.1 RC2

While following the Documentation i setup coppermine first and added groups, after i bridge the two programs, i have the BBS's Groups and coppermine's groups listed. I was wondering if it's safe for me to get rid of the Coppermine groups and just keep the SMF groups?

Joachim Müller · « **Reply #1 on:** April 21, 2006, 06:17:55 pm »

you can't get rid of the built-in coppermine groups. You're free to remove custom ones that you set up when unbridged.

News:

Author Topic: Removing the groups that were inputted by coppermine after bridge (Read 2869 times)

SeanK

Removing the groups that were inputted by coppermine after bridge

Joachim Müller

Re: Removing the groups that were inputted by coppermine after bridge