Print

[prasade]

i got problem getting cpg to work...
I am running cpg on NT with apache
1. instlled apache
2. configured php
3. installed and configured mysql
4. installed image magic
5. can access install.php
but when I enter the information and hit submit I get a blank page with one image (/images/logo.gif). no errors


any help you provide is higly appreciated.

regards
prasade

[Joachim Müller]

Using cpg1.3.2 instead of cpg1.2.1 is recommended. Try accessing the page with the hostname or the IP address in the address bar, not with http://localhost
Search the board for "blank page after install" or similar - afaik this has been asked before...

GauGau

[Tranz]

prasade,

Can you access any test php file using your setup? For me, I have to use http://localhost:X/ where X=port number (I think). You'd have to go over your documentation to figure that out.

[prasade]

Hello
thank you both for your response.
for the first response: yes I did tried with IP address, but I get the same result(just a logo). and I will look at the other posting. thank you for your advise.
for the second response: yes all my static content is served as expected.

thanks again.
prasade

[Joachim Müller]

Don't make a difference between static and dynamic content in this case - TranzNDance was asking you if php is actually parsed on your server. Do as suggested: create a file called test.php with this content

Code: [Select]

<?php print "Hello world"; ?>, upload it and run it in your browser. If it displays "Hello world", you're fine.

GauGau